Professional Power Amplifier - 2 x 2300W @ 4 ohms
Steel S15.2 is a professional power amplifier with an output power of 2 x 1520W @ 8 ohms / 2 x 2300W @ 4 ohms and a maximum bridged output power of 4600W @ 8 ohms. With a performance that stands out for its very low distortion and high fidelity, Steel S15.2 is equipped with a switching-mode power supply. Precisely thanks to the design of its power supply, the amplifier allows the peak power to follow the dynamic range of the musical program, being able to reproduce up to twice the RMS power, without clipping. This translates, basically, into peaks with much more dynamic range than a conventional-source amplifier. As one would expect in amplifiers of this range, the whole Steel series is equipped with a very efficient ventilation and has a comprehensive section of protections, to assure its correct operation in the most demanding situations.
Output
Output power (8 ohms): 2 x 1520W
Output power (4 ohms): 2 x 2300W
Output power (Bridge @ 8 ohms): 1 x 4600W
Performance
Input impedance:
Balanced: 20 kOhms
Unbalanced: 10 kOhms
Input sensitivity: 0.775Vor1.4V
Frequency Response: 20Hz~20KHz
THD: <0.05%
Damping factor (8 ohms) 10Hz-400Hz: >200
Crosstalk (at 1Khz): - 75dB
Signal to noise ratio: >100dB
Slew rate: 20V/us
Voltage gain: 38.3dB
Intermodulation distortion: =/<0.35%
Protections: Thermal, short circuits, no-load, on/off muting & RF interference
Connectors & back panel controls
Power supply connector: Interlock In
4 XLR-3 inputs
4 Speakon speaker outputs
Bridge, parallel & input sensibility switch
Physical
Cooling: Two Front-to-back fans, temperature controlled speed.
Net Weight: 7.5 kg. / 16.5 lbs.
Dimensions: 482x227x88 mm. / 19x9x3.5 in.
